RuarkAudio MR1 mk2 Mode D'emploi page 6

Setup
1
Position speakers
For best stereo reproduction, place left and right
speakers no less than 60cm (24in) apart with
the speaker with volume control on the right.
Avoid having objects in front of the speakers and
also ensure the underside of each speaker is
unobstructed.
2
Connect speakers together
Connect the two speakers with the interconnect
cable, inserting one end into the output on the right
speaker and the other end into the input on the left
speaker.
3
Connect to mains power
Fit the correct plug for your region to the mains
adaptor, it will "click" into place.
Connect the mains adaptor to the DC power socket
on the back of your MR1, then connect it to the wall
socket and where applicable turn on.
EN-6
4
Turn on your speakers
Press the control knob, or the standby button on the
remote. When turning on for the first time your MR1
will come on in Bluetooth mode and automatically
enter pairing mode (blue LED flashes).
5
Change source
Press the control knob to cycle between Bluetooth,
Aux input and Optical.
6
Adjust volume
Turn the volume control knob clockwise to increase
the volume, anticlockwise to decrease it or use the
volume buttons on the remote. When you reach the
maximum or minimum volume, the source indicator
LED goes off temporarily.
7
Standby
Press and hold the control knob for 1-2s until the
source LED turns off, or press the standby button on
the remote.