Operating Instructions - Westinghouse WSFS1009BK Manuel D'instructions

STAND FAN INSTRUCTIONS
1. Attach the outer tube (5) to the base (8) with the 4 screws (7)
as shown.
2. Loosen the height adjustment knob (4) on the outer tube and
extend the inner tube to the desired height.
3. Slide the cover ring (6) down the outer tube to rest on top of
the base.
Caution: The knob must be fully tightened before assembling
the fan head to the inner tube.
4. Secure the fan head (1) to the inner tube (3) with 1 screw (2).
FLOOR FAN INSTRUCTIONS
5. Attach the plastic connection plate (9) to the base (8) with the
4 screws (7) as shown.
6. Secure the fan head (1) to the connection plate (9) with 1 screw
(2).

OPERATING INSTRUCTIONS

WARNING: Do not use this product near windows, as this may
cause an electric shock or result in personal injury and/or damage
to property.
1. Place the fan on a dry, level surface.
2. Make sure the rotary switch is in the "0" (OFF) position. Plug
the unit into a 120 V/AC, 60 Hz mains outlet.
3. Adjust the fan head vertically to the desired angle.
4. To turn on the unit, turn the rotary switch to position "1" (LOW),
"2" (MEDIUM) or "3" (HIGH).
5. To stop the unit, turn the rotary switch to the "0" (OFF)
position, and then unplug the unit from the mains outlet.
6. Unplug the product from the mains outlet when it is not in use
or is left unattended.
WSFS1009BK_2 in 1 High Velocity 10 Stand Floor Fan_2L.indd 7
HOW TO USE
EN
7
5/12/2019 18:25:19