10
CLEANING
11
DISK
32
EN
Remove upper housing. Empty residual water from water tray,
fill up with tap water to maximum level indicated by the WA-
TERLINE marker and add 250 ml of Venta cleaner. Re-assemble
appliance and let it run for approx. 2 hours at low speed. We
recommend that you ventilate the room during this washing
procedure to avoid any odors which can occur if the appliance
is very dirty. Then remove upper housing and empty out dirty
water. Rinse out water tray and evaporation unit thoroughly. Fill
water tray in lower housing with tap water up to maximum level
indicated by the WATERLINE marker, re-assemble appliance
and switch it on. Touch CLEANING indicator 10 on the display
and hold for approx. 3 seconds until it goes out.
i
Every 6 months (in case of 24-hour constant operation), the
CLEANING indicator reminds you to carry out this action
1. Remove upper housing and take evaporation unit out of the
water tray.
A
a
2. Carefully release
holding arms a and
b from the axle and
remove bracket A from
evaporation roller.
5. Re-assemble the appliance and switch it on.
6. Touch DISK indicator 11 on the display and hold it for approx.
3 seconds until it goes out
i
The service life of the hygiene disk is approx. 4 months (in the case
of 24-hour constant operation). The service life depends on the
water hardness, water quality, daily evaporation performance and
number of operating hours. The DISK indicator reminds you to carry
out this action every 4 months (in the case of 24-hour constant
operation).
You can use the Venta ReNew recycling program to return the
hygiene disk to us (see RECYCLING & DISPOSAL).
b
3. Unscrew cap
B and remove it.
C
B
4. Remove
hygiene disk C
and replace it.