How To Trace Live Circuits - Greenlee POWER FINDER 2007 Manuel D'instructions Et De Sécurité

HOW TO TRACE LIVE CIRCUITS

Prior to plugging the transmitter into the circuit to be traced,
use an approved voltage tester, such as the Greenlee 6706,
6708, or 6709, to determine the voltage present. If the voltage
is less than 300 volts AC or DC, you may continue.
Do not connect the PowerFinder to power in excess of 300
volts! Connecting to more than 300 volts will cause damage to
the unit.
NOTE: For circuits other than 120 volts, use the accessory leads
provided with the unit.
Following are examples of possible connections:
EXAMPLE 1
Connection to a live 120 volt receptacle
(one with voltage present)
1) Plug the transmitter into the receptacle. The Green LED light
will blink intermittently.
2) Place the receiver RANGE switch in the HIGH position. Turn
the GAIN knob ON by rotating in a clockwise position (when
facing the front of the receiver).
Greenlee Textron Inc. / Subsidiary of Textron Inc.
2007 POWER FINDER™ Circuit Tracer
IMPORTANT
4455 Boeing Dr., Rockford, IL 61109-2988 USA 815/397-7070
6