The Machine Does Not Clean Properly; The Squeegee Does Not Dry Perfectly; Excessive Foam Production - Tornado BR 40/66 Mode D'emploi

THE MACHINE DOES NOT CLEAN
PROPERLY
1.The brushes do not have the suitable
bristle dimension: contact the authorized
technical assistance.
2.The brushes have got worn bristles.
Check the brushes wear condition and
eventually replace them.
To replace the brushes, see instructions
under paragraph "BRUSHES DISASSEM-
BLY" and "BRUSHES ASSEMBLY".
3.The detergent solution is insufficient:
open the solution valve more (see under
paragraph "FLOW ADJUSTMENT OF THE
DETERGENT SOLUTION").
4.Check that the liquid detergent is in the
recommended percentage.
5.Increase the brushes base pressure
(see under paragraph "ADJUSTMENT OF
THE BRUSHES PRESSURE").
Contact the authorized technical assis-
tance for advice.
THE SQUEEGEE DOES NOT DRY PER-
FECTLY
1.Check that the suction function is on and
that the recovery tank is not full.
2.Check that the squeegee rubbers are
clean (see under paragraph "SQUEEGEE
CLEANING").
3.Check the adjustment of the height
and the inclination of the squeegee (see
under paragraph "ADJUSTMENT OF THE
SQUEEGEE").
4.Check that the suction and the squee-
gee hoses are correctly inserted in their
proper seats on the recovery tank.
5.Clean the suction filter (see under
paragraph"SUCTION FILTER CLEAN-
ING").
6.Clean the squeegee hose (see under
paragraph"SQUEEGEE HOSE CLEAN-
ING").
7.Replace the rubbers if worn out.
Contact the authorized technical assis-
tance for advice.

EXCESSIVE FOAM PRODUCTION

Check that low foam detergent has been
used. If needed add small quantities of
anti foam liquid into the recovery tank.
Please be aware that a bigger quantity
of foam is produced when the floor is not
very dirty. In this case please dilute deter-
gent solution.
21