Suction Filter Cleaning; Brushes Cleaning; Squeegee Cleaning; Weekly Maintenance - Tornado BR 40/66 Mode D'emploi

4. Turn the key counterclockwise to turn off
the machine.
ATTENTION:
To carry out above operations with the
electric supply on, may cause damages to
hands.
ATTENTION:
This operation must be carried out using
gloves to protect from contact with danger-
ous solutions.
5. Open the bar of the right side rubber
after having released it pulling the stop (1)
upwards (1).
6.Open the door (2).
7.Extract the box holding its handle (3). For
its handling, it is convenient to use the two
wheels present on the opposite part of the
handle.
8.Empty the box into appropriate contain-
ers, in compliance with the respective rules
for liquid disposal.
9.Put the collection box back into its posi-
tion paying attention to the correct placing
of the sliding rollers.
10. Close the door (2) and reposition the
bar of the side rubber.

SUCTION FILTER CLEANING

1.Rotate the seat platform forward up to
the blocking of the support.
2.Take off the upper hose (1).
3.Unhook the closing lever (2).
4.Take off the plate with the filters (3) and
wash it with care.
5.Reassemble all parts.

BRUSHES CLEANING

Disassemble the brushes and clean them
with a water jet (for the brushes disas-
sembly see under paragraph "BRUSHES
ASSEMBLY AND DISASSEMBLY" and
"SIDE BRUSH ASSEMBLY AND DISAS-
SEMBLY").
18
ATTENTION:
To carry out brushes disassembly op-
erations with the electric supply on, may
cause damages to hands.

SQUEEGEE CLEANING

Keeping the squeegee clean guarantees
the best drying result.
For cleaning it is necessary to:
1.Take off the squeegee hose (4) from the
coupling.
2.Disassemble the squeegee (2) from its
support (1) loosening the stud bolts (3) and
then remove the squeegee.
3.Clean with care the internal part of the
squeegee inlet eliminating residual dirt.
4.Clean with care the squeegee rubbers.
5.Reassemble all parts.

WEEKLY MAINTENANCE

REAR SQUEEGEE RUBBER CHECK

Check the squeegee rubber for wear and
eventually turn or replace it.
For the replacement it is necessary to:
1.Take off the squeegee (see under
paragraph"SQUEEGEE CLEANING").
2.Unscrew the screws (1) that block the
rubber blade and take off the rubber.
3.Turn the rubber to a new side or replace
it.
To reassemble the squeegee reverse the
above operations, inserting the rubber on
the guides and blocking it with the rubber
holder blade.