Adjustment Side Rubbers; Brushes Assembly And Disassembly - Tornado BR 40/66 Mode D'emploi

ATTENTION:
Every type of floor requires a specific
adjustment. For example, concrete floors
(where the friction tends to be high) need
little pressure, while smooth floors (ceram-
ics) need higher pressure.
If the cleaning operations are always made
on the same type of floor, the adjustment
only needs to be made as a result of the
rubber wear.

ADJUSTMENT SIDE RUBBERS

To adjust the side rubbers, it is necessary
to act upon the knob (1). Screwing down,
more pressure is given and unscrewing,
pressure is being taken off. The reason
for the adjustment is to obtain an uniform
rubber bending.
NOTE: If the rubber should lower in the
rear part, it is necessary to restore the cor-
rect bending by acting upon the screw (2).
BRUSHES ASSEMBLY AND DISASSEM-
BLY
Normally, the machine is delivered with the
brushes assembled.
To assemble and disassemble the brush-
es:
1. Position the selector (4) for the adjust-
ment of the brushes pressure on position
P1.
2. Activate the machine (see under para-
graph "STARTING OF THE MACHINE")
positioning the selector (12) to the right to
choose the manual mode (MAN).
3. Activate the selector (14) of up/down
of the brushes base to lower the brushes.
Once that it is lowered, the brushes begin
to turn.
4. Turn the key counterclockwise to turn off
the machine.
ATTENTION:
To carry out brushes assembly operations
with the electric supply on, may cause
damages to hands.
ATTENTION:
This operation must be carried out using
gloves to protect from contact with danger-
ous solutions.
5. Open the bar of the right side rubber
after having released it pulling the stop (1)
upwards.
6. Take off the stop (2) then unscrew and
take off the knob so to open the blocking
support as shown in the figure.
12
7. Extract the support plates (3) and (4)
of the brushes pulling them outwards by
holding their handles.
8. Extract the rear brush (5) and the front
brush (6).
9. When reassembling the rear brush (5)
pay attention to the bristles design, so that
it will be assembled always in the same
direction as shown in the figure.