Batteries Recharging; Batteries Recharging With On-Board Charger (Optional); Batteries Disposal; Squeegee Assembly - Tornado BD 28/20 Mode D'emploi

The battery charge level is observed on the display with its respec-
tive symbol (see "VISUALIZATION CONTROLS").

BATTERIES RECHARGING

1. Bring the machine on a leveled surface.
2. Plug in the connector (1) of the battery recharger to the batteries
connector (2) placed in the rear part of the machine.
3. Proceed with the recharging keeping the recovery tank lifted (see
under "ACCESS TO THE BATTERY COMPARTMENT").
4. Maintain the connection with the battery recharger until the indi-
cation of the end of charge is observed on the charger.
Never disconnect the batteries connector during the recharging
phase.
BATTERIES RECHARGING WITH ON-BOARD CHARGER (OP-
TIONAL)
Bring the machine on a leveled surface near to a single-phase
120V 60 HZ socket (within 2 m), nominal current 10A.
Switch off the machine and proceed as follows.
1. Insert the plug into the mains socket.
2. Proceed to the recharging keeping the recovery tank lifted (see
under paragraph "ACCESS TO THE BATTERY COMPARTMENT"
in "BEFORE USE").
3. Do not take off the plug from the mains socket until the end of
charge. At the end of the recharging, remove the plug from the
mains socket.
Never leave the batteries completely discharged even if the ma-
chine is not used. In case of traditional lead/acid batteries, please
check the electrolyte level every 20 recharging cycles and as
needed, top up with distilled water at the end of the recharge. Never
leave the batteries discharged for more than two weeks.
Danger of gas exhalations and emission of corrosive liquids. Fire
danger: do not approach with free flames.

BATTERIES DISPOSAL

It is compulsory to dispose of exhausted batteries, classified as
dangerous waste, to an authorized institution according to the cur-
rent laws.

SQUEEGEE ASSEMBLY

1. Maintain the squeegee support (1) slightly lifted from the floor.
2. Insert the threaded parts of the two knobs (2) making them slide
inside the two slots on the support. Pay attention to put the wash-
ers (3) into position, there are two for each knob, so that they are
assembled one under and the other on top of the two slots present
on the support.
3. Attach the squeegee by rotating the two knobs (2) clockwise.
4. Insert the squeegee hose (4) into its coupling as shown in the
figure.
10