After Completing Work; Operation; Method Of Operation - Tornado SWB 26/8 Manuel D'instructions

2.7 After completing work

1. Drive to an appropriate maintenance area.
2. Stop the machine. Raise the side brush to its
idle position and switch the machine off.
3. Actuate the filter shaker.
4. Empty the debris container.
5. Check the brush space for accumulations of
dirt.
6. Check the charge status of the batteries.

3 Operation

3.1 Method of operation

The Tornado SWB 26/8 is a machine designed to
sweep and clean waste from hard floors and
carpets. The side brush (Fig. 4/1) sweeps the dirt
from corners to a position in front of the rotary
brush (Fig. 4/2). The rotary brush sweeps the
larger particle dirt overhead into the debris
container (Fig. 4/3). The finer dust picked up is
drawn up by the suction turbine, fed into the filter
system (Fig. 4/4) and filtered out.
Fig. 4
It is not permitted to clean the machine
with a pressure washer or steam
blaster.
Only dust-free air is fed back into the ambient air.
The machine is equipped with maintenance- free
batteries (Fig. 4/5), a specially adapted, fully
automatic battery charger (Fig. 4/6) and a total
discharge signal transducer to protect it against
total discharge.
9