Debris Container; Dust Vacuum - Tornado SWB 26/8 Manuel D'instructions

5.4.5 Changing the timing belt
The timing belt (Fig. 9/6) must be
checked every 500 operating hours and
changed in the event of wear.
1. Switch the machine off, unscrew the
locking bolt (Fig. 9/8) and open the
hood (Fig. 9/7).
2. Slacken the timing belt (Fig. 9/6) using

5.5 Debris container

1 Debris container
2 Locking mechanism
3 Seal
4 Handle
5.5.1 Emptying the debris container
Check the fill level of the debris container (Fig.
10/1) at regular intervals (max. load capacity 25
kg) and empty as necessary.
1. Switch the machine off and pull the locking
mechanism (Fig. 10/2) on the debris
container (Fig. 10/1) upwards.
5.5.2 Changing the seal
Check the seal (Fig. 10/3) weekly for signs of
wear and change it as necessary.
1. Switch off the machine and pull the locking
mechanism (Fig. 10/2) on the debris
container (Fig. 10/1) upwards.
2. Pull the debris container (Fig. 10/3) to the
rear and out of the machine using the handle
(Fig. 10/4).

5.6 Dust vacuum

1 Filter
2 Sealing strip
3 Filter support frame
4 Shaking device
5 Wing bolts
6 Holders
the tension pulley and remove
the belt.
3. Slacken the tension pulley and install
the new timing belt. The timing belt is
automatically tensioned by means of
a tension spring.
4. Close the hood (Fig. 9/7) and screw
the locking bolts (Fig. 9/8) back in.
Fig. 10
2. Pull the debris container to the rear out of the
machine using the handle (Fig. 10/4) and
dispose of the waste according to the
applicable environmental laws.
3. Reinstall the debris container and press it
against the locking mechanism until it audibly
latches into place.
3. Pull the seal for the debris container from the
filter support frame. Install a new seal.
4. Reinstall the debris container and press it
against the locking mechanism until it audibly
latches into place
Fig. 11
16