Inserting The Batteries; Disposing Of Batteries; Side Brushes - Tornado SWB 26/8 Manuel D'instructions

5.2.5 Inserting the batteries

Only the special batteries approved by
Tornado may be installed at the
prescribed position.
1. Install the two lower batteries in the battery
holder in accordance with Figure 7.
2. Lay the rubber mat on the batteries.
3. Place the other two batteries on the rubber
mat.
4. Tighten the lashing straps (Fig. 7/6).

5.2.6 Disposing of batteries

Used batteries with the recycling symbol contain
reusable commodities. In accordance with
symbol with the crossed out bin, these batteries
must not be disposed of in domestic waste.

5.3 Side brushes

1. Side brushes
2. Wing bolt
3. Carrier
4. Hood
5. Adjusting bolt
6. Counternut
7. Locking bolt
5.3.1 Changing the side brush
Check the side brush (Fig. 8/1) weekly and change in the case of wear.
1. Switch the machine off and lay it on its side.
2. Remove the wing bolt (Fig. 8/2) with the washer from underneath the side brush
(Fig. 8/1).
3. Pull the side brush off.
4. To fix the side brush align the drive pins on the side brush drive plate and secure with the wing bolt
and washer supplied.
5.3.2 Setting the sweeping pattern
In the case of brush wear and after changing the
side brush (Fig. 8/1), readjust the sweeping
pattern.
1. Switch the machine off; unscrew the locking
bolt (Fig. 8/7) and open the hood (Fig. 8/4).
2. Loosen the counternut (Fig. 8/6) and adjust
the sweeping pattern by turning the adjusting
bolt (Fig. 8/5) clockwise and counter
clockwise so that it touches the floor.
3. Tighten the counternut again and close the
hood.
4. Switch the machine on and allow the side
brush to run while standing still for a short
time.
5. Switch the machine off, raise the front a little
and pull it back.
5. Connect the battery poles to the connection
cables in accordance with the connection
plan (Fig. 7/9).
It is possible that sparking will occur when
connecting the batteries! Check a firm fit!
6. Close the hood (Fig. 7/8) and lock in place
with the locking bolt on the frame.
Fig 8
6. Check the sweeping pattern, comparing it
with a clock viewed driving forward.
When set correctly, the sweeping pattern
must make an impression on the floor
between approx. 10:00 and 4:00 o' clock.
7. Repeat the process, if necessary, until the
sweeping pattern is set correctly.
14