Technical Data - Tornado SWB 26/8 Manuel D'instructions

3.2.2 Operating elements on the machine
1 Knurled screw for the handle
2 Shaking device lever
3 Debris container lock
4 Side brush lever
5 Charger cable flap
Knurled screws for handle (Fig. 6/1)
The two knurled screws enable the handle
to be adjusted to a comfortable
height for the user.
Shaking device lever (Fig. 6/2)
In order to clean the filter in the dust
vacuum, switch the shaking device lever
several times quickly to the left and
right.

Technical Data

Machine length
Machine height (handle folded)
Machine width
Working width
Rotary brush width
Rotary brush diameter
Area Coverage, theoretical
Debris Container Volume
Filter Surface
Nominal Voltage
Power Consumption, rotary brush drive
Power Consumption, side brush drive
Power Consumption, suction turbine
Weight without batteries
Weight with batteries
Noise emission value
The sound pressure level (LpA) (at the ear of the operator)
measured according to DIN IEC 60335-2-72 under normal
working conditions:
Measurement inaccuracy (KpA):
Debris container locks (Fig. 6/3)
Pull the lock lever up in order to remove
the debris container.
Side brush lever (Fig. 6/4)
Use the lever to lower or raise the side
brush.
Charger cable flap (Fig. 6/5)
The battery charger cable is located behind the
flap to the right beside the operating
panel. Pull the lock downwards
to open the flap.
cm/in
cm/in
cm/in
cm/in
cm/in
cm/in
m²/sqft/h
Liter/Gal
m²/sqft
V
W/A
W/A
W/A
kg/lbs.
kg/lbs
dB (A)
dB (A)
11
Fig. 6
80/32
60/24
70/28
66/26
40/16
19/7
2400/26000
40/9
1.1/12
24
210/8.75
48/2
60/2.5
42/93
56/124
70
2