Operating And Indicator Elements; Operating Panel - Tornado SWB 26/8 Manuel D'instructions

3.2 Operating and indicator elements

3.2.1 Operating panel

1. Control lamp for rotary brush drive, side
brush drive and suction turbine
2. ON/OFF button for rotary brush drive, side
brush drive and suction turbine
3. Control lamp for side brush drive
4. ON/OFF button for side brush drive
5. Control lamp for battery charger operation
6. Charge control indicator
7. Drive bar
Fig. 5
ON/OFF button for rotary brush, side
brush and suction turbine (Fig. 5/1)
The button activates the rotary brush drive, side
brush drive and suction turbine so they are ready
to operate.
The side brush drive can be switched off
separately. The suction turbine cannot be
switched off separately which prevents the dust
vacuum being activated by accident.
To prevent unauthorized use of the
machine, switch the machine off using
the button (Fig. 5/1).
Control lamp for rotary brush drive, side
brush drive and suction turbine (Fig. 5/2)
The green control lamp indicates that the rotary
brush drive and suction turbine are ready to
operate. If the rotary brush or suction turbine is
overloaded, a safety shutdown is triggered and
the control lamp flashes.
ON/OFF button for side brush drive (Fig. 5/3)
The button can be used to switch off the side
brush drive independently of the rotary brush
drive and to activate it for use again.
Fig. 5/7
Control lamp for side brush drive (Fig. 5/4)
The green control lamp indicates that the side
brush drive is ready to operate. If the side brush
is overloaded, a safety shutdown is triggered and
the control lamp flashes.
Control lamp for battery charger operation
(Fig. 5/5)
This control lamp indicates that the batteries are
being charged
Charge control indicator (Fig. 5/6)
During the charging process, the machine's
electronics system controls the machine is not
switched on inadvertently and indicates the
charge status. The battery charge status is
indicated by 4 green and 1 red LED.
The battery voltage is depicted in 5 levels:
> 25.1 V = all green LEDs on
> 24.5 V = bottom 3 green LEDs on
> 23.9 V = bottom 2 green LEDs on
> 22.7 V = bottom green LED on
< 22.7 V = red battery LED flashes
Drive bar (Fig. 5/7)
The drive bar switches all the drives which are
ready to operate on or off.
The drive bar serves to prevent damage.
If the drive bar is released during operation, all
the drives are switched off.
10