Forza FRT304GN Manuel D'installation page 20

CAUTION: Do not attempt to attach the flexible connector directly to an external pipe thread. Connection
requires flare union adapters.
FOR ALTERNATIVE PIPING METHODS TO CONNECT THE APPLIANCE TO THE GAS SUPPLY, A TRAINED SERVICE
TECHNICIAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION.
Leak testing of the appliance shall be conducted by the installer according to the instructions given.
For Massachusetts Installations:
1) Shut-off valve must be a "T" handle gas valve.
2) Flexible gas connector must not be longer than 36 inch.
3) Not approved for installation in a bedroom or a bathroom unless unit is direct vent.
This appliance is designed for use with NG gas or LP gas. The gas pressure regulator is supplied with this appliance. It
must be installed in the gas ahead of the manifold entrance. It could be pre-set for use with natural gas. Check the data plate.
To use it with different gas it must be converted, as described in the Gas Conversion paragraph.
If at any time the appliance is to be used with a different type of gas, all the conversion adjustments must be made by a
qualified technician before attempting to operate the range with that gas.
GAS
PRESSURE
REGULATOR
POSITION
20