Before Calling For Service - LG S3 ERB Série Manuel Du Propriétaire

BEFORE CALLING FOR SERVICE

Your appliance is equipped with an automatic error-monitoring system to detect and diagnose
problems at an early stage. If your appliance does not function properly or does not function at all,
check the following before you call for service.
Operation
Problem
Smoke comes out
when the door is
opened
Full water supply tank
is empty after just one
use
Appliance makes a
loud vibrating noise on
startup
[Drying times are
taking longer than
estimated?]
Appliance is moving
from left to right while
operating
Sound of motor
whirring
Sound of water
running, boiling, or
hissing
Steam or hot air leaks
out when the door is
closed
The appliance won't
operate
Possible Cause
Door is opened during operation It is normal for steam or hot air to escape
Appliance is being used for
the first time
Moving hanger is balancing
load before operation
Clothes were extremely wet
when loaded
Floor under appliance is not
level or is not sturdy enough
to support the weight of the
appliance without flexing
Compressor is running during
drying
Steam being generated and
sprayed onto clothes
An item is caught in the door,
keeping it slightly open
Control panel has powered off
due to inactivity
Cord is unplugged
Circuit breaker/fuse is tripped/
blown
Appliance not connected to
120 V socket
Solutions
if the door is opened during operation.
A larger amount of water is needed the
first time the appliance is used to fill the
empty reservoir.
This is normal at the beginning of the
cycle. If the noise increases or continues
for a long time, call for service.
Drying times may be longer for very
wet or bulky clothing. Damp dry clothes
before putting them in the Styler. The
Styler stops automatically when clothes
are dry.
Install the appliance where the floor is
level and sturdy. Compensate for any
slight unevenness in the floor with the
leveling legs. See Leveling the Styler,
page 16.
This is normal.
This is normal.
Make sure all items are completely inside
the cabinet and nothing is caught in the
door, blocking it from closing completely.
This is normal. Press the Power button to
turn the appliance on.
Make sure cord is plugged securely into a
working outlet.
Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
appliance should be on a dedicated branch
circuit.
Make sure the cord is plugged into a
grounded socket rated for this appliance.
See the Product Specifications, page 12.
MAINTENANCE 41