Belkin TuneCast 3 Mode D'emploi page 13

Information
Electrical/Environmental Specifications
• P ower Requirement: 2x AAA batteries, or 5.5V DC, 75mA at CLA input
• Blade type Fuse: Current rating 2A, Voltage rating 32V
• O perating Temperature: 0° C to 45° C
• E xpected Continuous Run Time: 20 hours on new, 1175mAh alkaline batteries
Storage Precautions – When storing the TuneCast 3 for extended periods of time, Belkin recommends
the following:
1) Remove the batteries.
2) Keep out of direct sunlight and fluorescent lamps.
3) A void low (below 0° C) and high (greater than 35° C) temperature environments.
4) Avoid high humidity environments.
European Standards Compliance Statement
This equipment has been tested and found to be compliant with the requirements of the R&TTE Directive.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
TuneCast 3 is compliant to EN 301 357, EN 301 489, EN 60950, and EN 50371.
This product complies to the WEEE directive. For recycling information please follow the following link:
www.belkin.com/environmental
0673
EN
Information | 10