Gorenje NRF7181TNX Guide D'utilisation page 25

ERROR TYPE
SR – Set value
Blink on cooler
set value screen
SR – Set value
blink on freezer
and cooler set
value screen
SR – Set value
blink on cooler
set value screen
"--"
What to do if your refrigerator does not operate;
Check that;
• There is no power ,
• The general switch in your home is disconnected ,
• The thermostat setting is on "1" position ,
• The socket is not sufficient. To check this, plug in another appliance that you know which
is working into the same socket.
What to do if your refrigerator performs poorly;
Check that;
• You have not overloaded the appliance ,
• The doors are closed perfectly ,
• There is no dust on the condenser ,
• There is enough place at the rear and side walls.
If your fridge is operating too loudly;
Normal Noises
Cracking (Ice cracking) noise:
• During automatic defrosting.
• When the appliance is cooled or warmed (due to expansion of appliance material).
Click noise: Heard when the thermostat switches the compressor on/off.
ERROR TYPE
"Refrigerator
comp.
Not Cold enough"
"not cold enough
Warning"
Refrigerator comp.
too Cold
"Low voltage
Warning"
WHY
Ideal temperature for
Ref. Compartment is +4
C. If you see this warn-
o
ing your foods have risk
of spoiling.
IT IS COMBINATION
OF "NOT COOL
ENOUGH" ERROR
FOR BOTH OF THE
COMPARTMENTS.
The foods starts to
freeze because of the
too much cold tempera-
ture
When the power supply
gets lower than 170 V
the appliance gets to
steady position.
EN -24-
WHAT TO DO
1. Set the refrigerator tem-
perature to colder values or
set the super cooling mode
until the compartment gets to
normal temperature.
2. Do not open the door
much until this failure is off.
You will see this failure when
first starting the appliance. It
will be off after the compart-
ments gets normal tempera-
ture
1. Check if the "Super cooling
mode" is on
2. Decrease the refrigerator
temperature values
This is not a failure. This
prevents any damages on
the compressor. This warning
will off after the voltage gets
required level