Lubrication; Skirt Inspection; Recovery Tank Maintenance - Nilfisk Hydro-Retriever 2052 Mode D'emploi

A-14 / ENGLISH

LUBRICATION

Every 100 hours, using a grease gun pump grease into the Grease Fittings (A) as shown until grease starts to seep out around the bearing(s). Then wipe off excess
grease.
Grease fi tting locations are:
1 The two steering shaft fi ttings (access by removing the front fascia panel).
2 The two steering chain sprockets fi ttings (access by removing recovery tank and sprocket plate).
3 The main steering spindle fi tting (access by removing recovery tank and sprocket plate).
4 The rear steer wheel axle fi tting (access under rear of chassis).

SKIRT INSPECTION

Every 50 hours, inspect the rubber skirts all around the machine and in the broom housing; replace if damaged or worn.

RECOVERY TANK MAINTENANCE

Every 50 hours, inspect the gaskets that seal against the bottom of the recovery tank and around the recovery tank cover. Replace the gaskets if they are damaged or
not sealing properly.
A-14 - FORM NO. 56041606 - Hydro-Retriever 2052 / CR 1300
™