Stobag SKIROSOL SRCK 630 Instructions Et Avertissements Pour L'installation Et L'utilisation page 27

5 -
Caution
memorized in the tubular motor.
01. Caution!
other value if necessary.
02. of the new sensor.
03.
04. sensor to be memorized
rization successful). Note
new sensor is not possible.
– The signals may be beeps or small movements (depending on the motor model).
01.
02. Send a command to the system and, while it is executing, press sensor button P1 (yellow). Now, check that the motor
immediately stops (= sensor memorized).
www.stobag.com
may only be used if one or more radio codes have already been
6 -
Once the sensors have been memorized, they must be calibrated, as follows.
Note to the procedures
having properly.
(Quick reference guide - Step 3)
01.
02. Illuminate the sun sensor with bright sunlight; if the day is very cloudy, use a lamp. The brightness of the light striking
-
the sensor must be at least 1Klux.
03.
exceeded).
04. Now obscure the sun sensor with a hand or a black cloth which lets no light through, and check: a
*) (= memo-
to raise the awning.
05. Remove your hand or the cloth.
06.
(*) - this value can be changed later with the procedure and values given in chapter 7.
(Quick reference guide - Step 4)
Caution
01. Obscure the sun sensor with a hand or a black cloth which lets no light through.
02.
03. Place a finger over the rain sensor and hold it there. Now check: a
raise the awning (caution!
orange briefly a number of times.
04.
06. Remove your hand or the cloth.
07.
(*) - this value can be changed later with the procedure and values given in chapter 7.
(Quick reference guide - Step 4)
01.
02. Rotate the wind sensor blades and check: a) the motor must raise the awning; b) the sensor must prevent the motor
receiving any other commands (thus protecting the awning against the wind); c
times (= threshold exceeded).
03. Now stop the blades and check: a
threshold); b) the sensor must deactivate the protection function: send a transmitter command to the motor, the awning
should respond.
04.
(*) - this value can be changed later with the procedure and values given in chapter 7.
green
b) the sensor must tell the motor
*
b
green and red alternately.
*
(= return to within
*
-
27