CASO DESIGN WineSafe 12 Manuel D'utilisation Original page 19

The wine refrigerator seems
to make to much noise
The door will not
properly.
LED could not display.
LED display error - Lo
Buttons are not functional.
Compressor will not start
Compressor re-start
Dew on the surface
cabinet：
Liquid sound
Condensation formed inside
the cabinet
Error code E2
Attention
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
The wine refrigerator is not level. Check the fan.
close The wine refrigerator is not level. The door is reversed and
not properly installed. The seal is weak. The shelves are out
of position.
Main control board does not work. PCB Problem. There is
some problem with the plug.
Weak quality of display. Temperature point is out/off. Check
the service center.
Temperature controller panel is damaged.
Room temperature is lower than desired temperature.
Compressor will stop working when cooling system in the
cabinet reaches
working when the desired temperature is achieved. Allow a
minimum 5 minute interval before re-starting.
of The surface of wine cabinet especially the glass door
appears to have some frost if item is in a damp room. This is
due to the moisture in the air coming into contact with the
cabinet. Please wipe it away with dry cloth.
（1) The sound of compressor when starts or stops working
（2) The flowing sound of refrigerant in the refrigeration
system
（3) The evaporating sound of refrigerant in the evaporator
Under the environment with high level of humidity or the
door of wine cabinet has been left open for a long period or
opened frequently, wipe off the door and walls and leave the
door closed as long as possible.
Desired temperature is not reached.
If necessary defrost the device (Please follow the hints for
manual defrosting in chapter cleaning).
preset temperature, and will re-start
19