D-Link SmartPro DGS-1510 Guide De Démarrage page 4

Step 2
In order to login and configure the switch via an Ethernet
connection, the PC must have an IP address in the same
range as the switch. For example, if the switch has an
IP address of 10.90.90.90, the PC should have an IP
address of 10.x.y.z (where x/y is a number between 0 ~
254 and z is a number between 1 ~254), and a subnet
mask of 255.0.0.0.
Open your web browser and enter http://10.90.90.90
(the factory-default IP address) in the address box. Then
press <Enter>.
Figure 7. Enter the IP address 10.90.90.90 in the web
browser
The web configuration can also be accessed through the
DNA. You can click the IP hyper link in the device list in
the DNA to open the web GUI of devices.
NOTE: The switch's factory default IP
address is 10.90.90.90 with a subnet
mask of 255.0.0.0 and a default
gateway of 0.0.0.0
Step 3
When the following logon dialog box appears, leave both
User Name and the Password in blank and choose the
language of the Web-based Management interface then
click Login.
Figure 8. Enter Network Password window
Step 4
Before entering the Web-based Management, the
Smart Wizard will guide you to quickly configure some
functions, such as Ip Information and SNMP Settings.
If you don't plan to change anything, click Exit to exit
the Wizard and enter the Web-based Management.
For a detailed look at the Smart Wizard's functions,
please refer to the Smart Wizard introduction in the user
manual.
4
DNA (D-Link Network Assistant)
The DNA (D-Link Network Assistant) included on the
installation CD is a program for discovering Smart
Switches with the same L2 network segment connected
to your PC. This tool can support windows 2000, XP,
Vista, and Windows 7. There are two options for the
installation of DNA (D-Link Network Assistant), one is
through the autorun program on the installation CD and
the other is manual installation.
Option 1: Follow these steps to install the DNA
(D-Link Network Assistant) via the autorun
program on the installation CD.
1. Insert the CD into your CD-Rom Drive.
2. The autorun program will pop up automatically
3. Simply click on the "Install DNA (D-Link Network
Assistant)" button and an installation wizard will guide
you through the process.
4. After successfully installing the DNA, you can find it
under Start > Programs > D-Link > DNA.
5. Just connect the SmartPro Switch to the same L2
network segment of your PC and use the DNA
(D-Link Network Assistant) to discover the Smart
Switches.
Option 2: Follow these steps to install the DNA
(D-Link Network Assistant) manually.
1. Insert the Utility CD into your CD-Rom Drive.
2. From the Start menu on the Windows desktop, choose
Computer.
3. Double click on your CD-Rom/DVD-Rom Drive to start
the autorun menu, or right click on the Drive to open
the folder. Select DNA (D-Link Network Assistant) and
double click on the setup.exe file.
4. Follow the on-screen instructions to install the utility.
5. Upon completion, go to Start > Programs > D-Link >
DNA and open the DNA (D-Link Network Assistant).
6. Just connect the SmartPro Switch to the same L2
network segment of your PC and use the DNA
(D-Link Network Assistant) to discover the Smart
Switches.
For detailed information of DNA, please refer the user
manual.
Connecting The Console Port
To connect to the serial port, a special Console Cable
must be used. This cable is included with this product's
packaging. The cable referred to as an RS-232 to RJ-45
connector cable specifically pinned to connect to this
switch's serial port by using the correct pin configuration.
To connect to the console port of the Switch, use the
following steps: