Detecting; Detecting Report And Clearing - Q-Connect KF 14926 Manuel D'utilisation

Detecting

You need not select currency type because the machine can distinguish the currency type
automatically when you pass a banknote. One of the LED indicators turns on to indicate the
current currency type.
When the machine detects an insertion of a banknote in the feed port, it will automatically
start the motor and begin a detecting procedure. There is no limitation on side or direction
of the banknotes for most currency types such as Euro and etc. But for some of other
banknotes (e.g. Swiss Franc), there are rules for the inserting direction and side. When
inserting a banknote, please make sure the banknote are put in straightly.
If the banknote is a genuine one, the number of sheets will be increased by one and the total
value will be added with the current value, then the banknote will go out in the selected exit
direction. (See Figure 1) When the number of sheets is beyond 999 or the total value is
beyond 9999, the data will be automatically set to zero.
Total number
Exit
Direction
Figure 1
If the banknote is a suspicious one, it will be rejected and exit from the feed port with 3
beeps. And at the same time, the light of "ON/OFF" key will glint, corresponding error code
will be displayed on "Sheets Display Window"(See Figure 2). The error codes are listed at
Troubleshooting.

Detecting Report and Clearing

After finishing detection, press "REP/DIR" key to enter report mode. When checking the
notes detection record, it is possible for you to press "REP/DIR" key again and again to
display records for different denomination and its pieces by turns. (See Figure 3) When
checking the record, if you feed banknote, the detector will automatically exit the report
mode. Press "CLR" key and hold it for 2 seconds to clear records.
14
Currency
Type
Total
Value
Error
Code
Figure 2