What To Do If - IKEA FROSTIG SC100/17 Mode D'emploi

ENGLISH

What to do if...

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent
person must do the troubleshooting that is
not in this manual.
Problem
The appliance is noisy.
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on
ground.
Possible cause
The appliance is not installed
properly.
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
The appliance has no power.
There is no voltage in the
mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
the There is too much water in the
air deflector.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Solution
Check if the appliance stands
stable (all the feet should be on
the floor).
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open lon-
ger than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Clean the air deflector.
12