Ip Address Selection - Avigilon 5.0MP-HD-DOME-DN Guide D'installation

connection status LED shuts off after the dome camera has been
connected to a server
Table:Connection Status LED States
Connection
State
No Link
Obtaining IP
Address
Connecting to
a server
Upgrading
Firmware
Connected

IP Address Selection

Once connected to a network, the dome camera will attempt to locate
and obtain an IP address from a DHCP server. If this fails, an IP
address will be selected using Zeroconf (APIPA).
If the IP address is set using Zeroconf, the IP address will be in the
169.254.* subnet. A static IP address can be set from the Avigilon
Control Center software, consult the software user guide for details.
Connection
Status LED
Off
One short
flash every
second
Two short
flashes every
second
Two short
flashes and
one long flash
every second
On
Description
Not physically connected to any
network device
Attempting to obtain an IP address
An IP address has been obtained
and is attempting to connect to the
server
Updating the firmware
Connected to the server
13