Thermal Imaging Camera; Power Supply - Bosch GTC 400 C Professional Notice Originale

18 | English

Thermal imaging camera

– Button cell
– Battery life approx.
Wireless connectivity
Max. WLAN transmission power
WLAN operating frequency range
Specific absorption rate (trunk, average value per 10 g of tis-
sue)
Weight according to EPTA-Procedure 01:2014
– With rechargeable battery
– With non-rechargeable batteries
Dimensions (length × width × height)
Protection rating (excluding battery compartment)
Permitted environmental conditions
– Recommended ambient temperature during charging
– Operating temperature
– During storage with a rechargeable battery
– During storage without a rechargeable battery
Max. altitude
Pollution degree according to IEC 61010-1
F)
Relative air humidity max.
Recommended rechargeable batteries
Recommended chargers
A) At an ambient temperature of 20 to 23 °C and an emissivity of > 0.999, measuring distance: 0.3 m, operating time: > 5 min, aperture of
60 mm
B) Plus use-dependent deviation (e.g. reflection, distance, ambient temperature)
C) Depends on battery in use
D) At an ambient temperature of 20–30 °C
E) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by condensation is expected.
F) In accordance with standard VDI 5585
Technical data determined using the battery that comes with the product.
The serial number (2) on the type plate is used to clearly identify your measuring tool.
Assembly

Power supply

The measuring tool can be operated either with conventional
non-rechargeable batteries or with a Bosch lithium-ion bat-
tery.
Operation with battery adapter (removable)
(see figures A and B)
The batteries are inserted into the battery adapter.
The battery adapter is intended only for use in desig-
u
nated Bosch measuring tools and must not be used
with power tools.
To insert the batteries, slide the receptacle (21) of the bat-
tery adapter into the battery bay (18). Place the batteries in
1 609 92A 6KU | (25.10.2021)
CR2450 (3 V lithium battery)
the receptacle as shown in the picture on the cap (20). Push
the cap over the receptacle until you feel it click into place.
To remove the batteries, press the release
buttons (19) on the cap (20) and pull the cap
off. Hold the measuring tool with the battery
bay (18) facing upwards to ensure that the
batteries do not fall out when you do this. Re-
move the batteries. To remove the receptacle (21) from in-
side the battery bay, reach into the receptacle and pull it out
of the measuring tool, applying light pressure to the side wall
as you do so.
Note: Do not use any tools (e.g. a screwdriver) to remove
the battery, as this could break the cover.
Always replace all the batteries at the same time. Only use
batteries from the same manufacturer and which have the
same capacity.
GTC 400 C
60 months
WLAN
45 mW
2.402–2.480 GHz
< 0.22 W/kg
C)
0.54–0.74 kg
0.49 kg
63 × 95 × 235 mm
IP53
0 to +35 °C
–10 to +45 °C
–20 to +50 °C
–20 to +70 °C
2000 m
E)
2
90 %
GBA 10,8 V
GBA 12 V
GAL 12...
GAX 18...
Bosch Power Tools