Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Microphone Boom
6.4 POSITIONING THE SPEAKERS
For best audio results, make sure that both of your speakers are placed as closely
as possible just opposite your ears.
The following applies to both sides of the SRC-System™:
1. Open the rear red button located under the interior lining that covers the cheek
pads (the button is held by a black ring). Lift the lining slightly.
2. Attach the corresponding oval Velcro pads to the speaker-shaped indentations on
the EPS (expanded polystyrene) and position the speakers on the Velcro pads.
3. Close the red button, making sure it is still inside its black holding ring.
Snap Button
Snap Button
NOTE: Optional speaker pads are provided to boost the speaker volume if needed by
bringing the speakers closer to your ears.
To use, simply place the speaker pad between the Velcro pad in the helmet
indentation and the speaker.
6.5 POSITIONING THE MICROPHONE
To assure smooth closing (flip-down) of the helmet's chin section, first remove its
triangular Anti-Noise Pad and proceed as follows:
1. Bend the flexible microphone boom as shown in the image.
2. Press the microphone towards the center of your mouth.
3. Flip-down and close the chin section of your helmet. You may need to use both
hands to close the chin section properly.
4. While the chin section is closed and the visor is open, insert your hand into the
opening of the visor and push the microphone away, towards the center of the
chin section directly opposite your mouth.
6.6 REMOVING THE SRC-SYSTEM™ FROM YOUR HELMET
1. Detach both speakers from the Velcro on the helmet.
IMPORTANT: Make sure not to pull on the Antenna connector.
2. Carefully lift and push the Acoustic Collar's arch from the center.
3. Release the Acoustic Collar's pins from their corresponding indentations inside
the helmet's rim.
4. Pull out the Antenna connector from its pocket and carefully disconnect it.
11
Publicité
Chapitres
Table des Matières
Dépannage
