Troubleshooting - Korg Nuvibe Manuel D'utilisation

b. Pedal
Press down on the pedal to increase the modulation speed. Release
the pedal to reduce the modulation speed.
c. CANCEL switch
Press this switch to cancel modulation.

Troubleshooting

Power won't turn on
• Could the power switch have been set to STANDBY?
• Is the AC adapter connected correctly?
• When using batteries, are the batteries installed?
• When using batteries, are the negative and positive orientation of the
batteries correct?
• When using batteries, could the batteries be depleted?
No sound
• Has the VOLUME knob been set so that sound is being output?
• Are the guitar amp, mixer and other devices connected correctly to
the jacks?
• Have the guitar amp, mixer and other devices been turned on and
have their volumes been raised?
Short battery lifespan
• Could the Nuvibe have been left turned on? Since the INPUT jack
does not function as a power switch, simply unplugging a cable does
not turn it off. When the Nuvibe is not being used, set the power
switch to STANDBY.
• Are new alkaline batteries being used?
No effect is applied
• Is the EFFECT LED lit up?
• Could the INTENSITY knob be set to MIN?
• Could all WAVE sliders be set to the same position? Move the sliders
to create the waveform.
• When the expression pedal is connected, could the CANCEL switch
in the heel area have been pressed? Press on the expression pedal.
Power turns off unexpectedly
• Could the batteries be depleted? If the EFFECT LED is not lit up,
replace the batteries with new ones.
Something is wrong with the sound
• Try changing the WAVE sliders to the recommended settings (page
5).
• Adjust the INTENSITY knob and SPEED knob again.
Using the knobs, sliders, switches or expression pedal
does not change the sound
• Are the batteries depleted?
• When the expression pedal is connected, the SPEED knob on the
Nuvibe is disabled.
• When the CANCEL switch on the expression pedal is pressed, the
INTENSITY knob on the Nuvibe is disabled.
- 7 -
Nuvibe Owner's manual