Specifications; Troubleshooting - Toto TLE05701U Manuel D'installation Et D'utilisation

Water Supply Pressure Water Supply Pressure
Water Supply Connection Water Supply Connection
Ambient Temperature Ambient Temperature
Humidity Humidity
Recommended temperature range Recommended temperature range
(hot supply) (hot supply)
Recommended temperature range Recommended temperature range
(cold supply) (cold supply)
Temperature Adjustment Range Temperature Adjustment Range
at outlet at outlet
Minimum Flow Minimum Flow
Problem Problem
Water won't begin Water won't begin
running running
Low flow rate Low flow rate
Water temperature Water temperature
is too high is too high
Water temperature Water temperature
is too low is too low
Water temperature Water temperature
is not controlled is not controlled
properly properly

SPECIFICATIONS

SPECIFICATIONS
@30 psi (206 kPa), Cold ambient temperature,

TROUBLESHOOTING

TROUBLESHOOTING
Cause
The stop valve is turned off. The stop valve is turned off.
Water supply is suspended. Water supply is suspended.
The strainer or the regulating screen The strainer or the regulating screen
is clogged. is clogged.
The stop valve is not fully opened. The stop valve is not fully opened.
The strainer or the regulating screen The strainer or the regulating screen
is clogged. is clogged.
The temperature control handle is The temperature control handle is
set at "H". set at "H".
The stop valve connected to the The stop valve connected to the
cold-water supply is not fully opened. cold-water supply is not fully opened.
The temperature control handle is The temperature control handle is
set at "C". set at "C".
The stop valve connected to the hot The stop valve connected to the hot
water supply is not fully opened. water supply is not fully opened.
The hot water supply temperature is The hot water supply temperature is
lower than 120 °F. lower than 120 °F.
One side of the stop valve is not fully One side of the stop valve is not fully
opened. opened.
The strainer or the regulating screen The strainer or the regulating screen
is clogged. is clogged.
Minimum required water pressure: 15 psi Minimum required water pressure: 15 psi
(100 kPa) (Flowing) (100 kPa) (Flowing)
Maximum water pressure: 80 psi (551 kPa) Maximum water pressure: 80 psi (551 kPa)
G1/2 compatible with 1/2 NPSM G1/2 compatible with 1/2 NPSM
32-104 °F (0-40 °C) 32-104 °F (0-40 °C)
Max. 90% RH
120-180 °F (49-82 °C) 120-180 °F (49-82 °C)
39-80 °F (4-27 °C) 39-80 °F (4-27 °C)
Ambient temperature ~ 120 °F (49 °C) Ambient temperature ~ 120 °F (49 °C)
(Factory setting 97±4 °F (36±2 °C) (Factory setting 97±4 °F (36±2 °C)
@30 psi (206 kPa), Cold ambient temperature,
Hot 176°F (80 °C)) Hot 176°F (80 °C))
0.35 gpm (1.3 L/min) 0.35 gpm (1.3 L/min)
Cause
- 6 - - 6 -
Max. 90% RH
Solution Solution
Turn on the valve. Turn on the valve.
Wait until the water supply is Wait until the water supply is
restored. restored.
Clean the strainer and the Clean the strainer and the
regulating screen. regulating screen.
Open the stop valve fully. Open the stop valve fully.
Clean the strainer and the Clean the strainer and the
regulating screen. regulating screen.
Set the temperature control Set the temperature control
handle to the middle point. handle to the middle point.
Open the cold-water stop Open the cold-water stop
valve fully. valve fully.
Set the temperature control Set the temperature control
handle to the middle point. handle to the middle point.
Open the hot water stop Open the hot water stop
valve fully. valve fully.
Set the hot water supply Set the hot water supply
temperature to 120 °F. temperature to 120 °F.
Open the stop valve fully. Open the stop valve fully.
Clean the strainer and the Clean the strainer and the
regulating screen. regulating screen.