Before Using The Product - KS Tools 160.0424 Notice D'utilisation

2. BEFORE USING THE PRODUCT

① LOOSEN THE AIR EVENT SCREW
③ OPERATE THE TRANSMISSION JACK AND MAKE SURE IT'S IN THE HIGHEST POSITION
④ USE A 3MM WRENCH TO LOOSE THE
INNER HEXAGON SCREW IN 1 CIRCLE OR 1.5
CIRCLES
⑥ CHECK IF THE TRANSMISSION JACK WILL GO UP STEDILY. IF NOT PLEASE REPEAT STEP 2
TO 5 BLEED THE AIR AGAIN UNTIL THE TRANSMISSION CAN WORK SMOOTHLY
3. Test the jack, unladed, by raising it to full height and then lowering it. Open the release handle (02) to the right
slowly to control the rate of descent.
② OPEN THE RELEASE HANDLE AND KEEP IT
OPEN. OPERATE THE FOOT PEDAL 5-10 TIMES.
THEN CLOSE THE RELEASE HANDLE
⑤ OPERATE THE PEDAL BY 2 OR 3 TIMES
UNTIL THE OIL WITHOUT BUBBLE IS COMING
OUT FROM THE HOLE. THEN TIGHTEN THE
INNER HEXAGON SCREW