Assa Abloy 309N Notice De Montage page 48

!
Fig. 9 :
Adjust the panic side
EN
48
Changing the panic side
The panic side of a lock with B-function ("B-function (changeover function)", page 33) must be adjust-
ed before installation. The panic side of the lock must be adjusted such that the door can be opened in the
escape direction (normally outward from inside) with the door handle, regardless of the locking status of
the lock.
Warning!
An incorrectly adjusted panic side can result in life-threatening danger and risk of injury: After
installing the lock, check whether the locked door can be opened in the escape direction.
2,5 mm
1.
2.
The locking screws are always located on the panic side.
1 Press and hold the latch bolt.
2 Press the control latch.
3 Release the latch bolt while pressing the control latch.
 The bolt is blocked.
4 Unscrew the locking screws (Fig. 9).
5 Re-insert the locking screws on the opposite side
(torque 2.5 Nm).
 The panic function is now set on the opposed lock side.
 Check the panic function using a latchkey and a spindle (9
mm) before installing the lock.
Installation