General Maintenance - Ego Power+ LB6000E Manuel De L'opérateur

Table des Matières

Les langues disponibles

4. Snap the waist buckle and adjust its length so that the

backpack is securely supported by your hips

(Fig. L & M).

NOTICE:

The backpack shouldn't sit too high on your

back; it should be positioned closer to your hips than to

your shoulders.

5. Readjust the shoulder straps for security and comfort.

Makes sure that the backpack sits securely on your

back, with the weight supported by the waist strap,

and without excess movement when you move (Fig. N).

6. Insert any extra length of belt around the waist into the

elastic on both sides (Fig. O).

7. To detach the tool from your back, just press the waist

and chest buckles to release them and lower the tool

(Fig. P).

To Adjust The Control Handle

1. Loosen the wing nut to adjust the handle forward or

backward as needed (Fig. Q & R) and then tighten the

wing nut to secure the position of the handle.

2. You may also rotate the handle as needed for comfort

(Fig. S).

3. To enlarge the area you are cleaning, move the tube to

the left or the right (Fig. T).

TO START/STOP THE BLOWER (FIG. U)

Air-Speed Trigger Only

◾

Depress the air-speed trigger to turn on the blower.

◾

The air speed of the blower is controlled with the

variable speed trigger. More pressure on the trigger

results in higher blowing speeds; less pressure on

the trigger results in lower blowing speeds. Adjust the

speed to suit the task at hand.

◾

Release the air-speed trigger to turn off the blower.

Speed/Lock-On Dial Only

The blower can be turned on and locked at any speed

with the speed /lock-on dial.

◾

Turn the speed/lock-on dial clockwise to start the

blower. The air speed will increase as the dial is

rotated clockwise.

◾

To decrease the air speed, turn the speed/lock-on dial

counterclockwise.

◾

Keep turning the speed/lock-on dial counterclockwise

to the off position to stop the blower.

56 VOLT LITHIUM-ION CORDLESS BACKPACK BLOWER — LB6000E

Notice: If the speed/lock-on dial is not turned back to the

off position before turning the blower on, the blower will

not start through the speed/lock-on dial when a charged

battery is installed. This is a protection feature to help

prevent accidental startup. Depress the air-speed trigger

can deactivate the protection.

Press the boost button while working to temporarily

increase the air speed to the maximum level. The blower

will resume the previous speed when the boost button is

released.

Fig. U parts description see below:

U-1

Speed/lock-on Dial U-3

U-2

Boost Button

Tips For Using The Blower

◾

To keep from scattering debris, blow around the outer

edges of a debris pile. Never blow directly into the

center of a pile.

◾

To reduce sound levels, limit the number of pieces of

equipment used at any one time.

◾

Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces if water

is available.

◾

Watch out for children, pets, open windows, or freshly

washed cars, and blow debris safely away.

◾

After using blowers or other equipment, clean up!

Dispose of debris properly.

◾

It is not recommended to use the blower at a high

speed for a long time, as large vibration and noise may

be harmful to your health.

MAINTENANCE

WARNING:

When servicing, use only identical

replacement parts. Use of any other parts may create a

hazard or cause product damage. To ensure safety and

reliability, all repairs should be performed by a qualified

service technician.

WARNING:

To avoid serious personal injury, always

remove the battery pack from the product when cleaning

or performing any maintenance.