Worx HYDROSHOT WP650 Mode D'emploi page 11

TROUBLESHOOTING
Symptom
Machine turns on but it does not
draw any water or there is not
sufficient pressure.
Machine does not start.
Machine stops automatically.
Machine does not draw any
water after long time storage.
Machine sprays improperly.
Machine is "spitting".
Spraying performance is weak.
Machine runs for a short period
then shuts off.
20V Sanitizing pressure washer
Possible causes
The water inlet is loose.
The filter screen is missing. (See Fig.
J1, J2)
The filter screen is blocked. (See Fig.
J1, J2)
The battery pack is not attached well.
Battery pack is not charged.
Defective battery.
Battery pack is empty.
Additional air could be sucked into the
machine.
Nozzle is clogged, hose is partially
disconnected, or fluid in tank is low.
Liquid in tank is too thick to spray out.
Filter needs to be cleaned.
Solution is too thick.
Battery needs charging.
Solution is too thick.
Solution
Retighten the water inlet.
Contact Worx service agent to get a
filter screen.
Clean the filter screen regularly.
Reinstall the battery pack.
Replace with a new battery pack or
recharge the battery pack.
Replace with a new battery pack.
Replace with a new battery pack or
recharge the battery pack.
It is recommended to pour water directly
into the hose adapter with the machine
turned on to empty the air. Ensure water
sprays out of the nozzle before working.
Clean the filter. Check hose connections
and make sure there is sufficient fluid
in the tank.
Empty the tank, clean both the tank and
filter, then try again. Make sure that all
liquid used in the sprayer are as thin as
water.
Clean the filter.
Make sure that all liquid used in the
sprayer are as thin as water.
Recharge the battery.
Make sure that all liquid used in the
sprayer are as thin as water.
11
EN