Adjustment Knob; Timer - CARVIN SANICLEAR 10 Manuel D'installation Et D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If your pool has natural stone as coping or decking, please check with a stone installation specialist for the maintenance
of the stone before installing the salt chlorinator.
DESIRED LEVEL ADJUSTMENT KNOB
This setting is used to control the percentage of time the SANICLEAR system will produce chlorine. Adjust this setting
to increase or decrease the chlorine output duration. The reading is from 5 percent output to 100% output chlorine
production duration of the SANICLEAR system.
For example; if the adjustement knob is at 60%, the SANICLEAR system will produce chlorine (at its top rate) during
60% of the time, the other 40% of the time, the SANICLEAR system will not produce anything.
Setup the Timer
Follow these step to setup the timer
1. Raise one red tab for each 15 minutes you want your device activated. Example: (4) tab raise
will make your device work for 1 hour
2. When tabs are in down position, the device will be off
3. Turn the knob to setup the time. Your new synchronisation device is a 24h timer.
4. Plug you device in the inlet under the control box (A)
5. Plug the control box power cord in an electric power outlet. (B)
6. Move the toggle in timer position
A. Connect the pump with the system.
B. Connect the cord to power supply.
33

Publicité

Chapitres

Table des Matières
loading

Table des Matières