Electrical Information; Cell & Flow Switch - CARVIN SANICLEAR 10 Manuel D'installation Et D'opération

Installation of the cell and flow switch:
The switche (flow switch) cable has connector at the end that plug into the salt chlorinator to facilitate installation. On
the bottom of the enclosure, there is the flow switch with a plug (very similar to a telephone jack) located outside. See
figure below for the locations of the switches.
Connect the cell cord to the cell before install the flow switch. Cell cord is a little bit tight. Make sure the brass pole is
going through to the edge.

Electrical information:

Connect the Salt chlorinator DIRECTLY TO 120vac POWER (not to be connected through relay or timer).
28