Introduction; Intended Use; Parts Description; Technical Data - ULTIMATE SPEED ULG 12 A2 Mode D'emploi

Introduction

These original operating instructions / the device uses the following pictograms:
Read original operating instructions!
Note
Observe the warning and safety
instructions!
Car battery charger with jump
start function ULG 12 A2
Introduction
Congratulations!
You have chosen high-quality device
by our company. Familiarise yourself
with the product before using it for the first time.
Carefully read the following original operating in-
structions and safety notices. Initial operation of this
tool must be performed by trained personnel.

Intended use

The Ultimate Speed ULG 12 A2 is a car charger with
impulse trickle charge (Chip Software) suitable for
charging and trickle charging the following 6 V or
12 V rechargeable lead batteries with electrolyte
solution, AGM batteries, lead-acid batteries, deep
cycle (marine batteries), or gel batteries:
• For automotive and motorcycle batteries with
12 V / 6 V and 8–180 Ah capacity
You can also regenerate drained batteries (depend-
ing on battery type). The car charger features a
protective circuit against sparking and overheating.
Any improper or incorrect use will void the warranty.
The manufacturer is not liable for damage caused by
improper use. The device is not intended for com-
mercial use.
Note: The car charger is not suitable for charging
electric vehicles with built-in rechargeable battery.
6 GB/IE/NI
Caution! Risk of electric shock!
Caution! Explosion hazard!
Dispose of packaging and device in
an environmentally-friendly way!

Parts description

Digital display button
1
Battery type button
2
Charge Start button
3
Fuse with cover
4
"+" Terminal connection cable (red)
5
"–" Terminal clamp (black)
6
"+" Terminal clamp (red)
7
"–" Terminal connection cable (black)
8
Mains cable
9
Digital display
10

Technical Data

Input voltage:
Reverse current*:
Rated output voltage:
Charging current:
Battery type with:
Housing protection type: IP 20
* = Reverse current is the battery current the charger
uses when not connected to power.

Scope of delivery

Check the contents and device along with
all parts for damage immediately after
unpacking. Do not use if the device or
parts are damaged.
230 V∼ 50 Hz
< 5 mA (no AC input)
6 V / 12 V
2 A, 6 A, 12 A ± 10 %
12 V / 6 V and
8–180 Ah capacity