Operation; Product Properties; Connecting; Disconnecting - ULTIMATE SPEED ULG 12 A2 Mode D'emploi

Safety notices / Operation
member standby operation also
consumes electricity.
Always be alert and always be
careful what you do. Always
proceed with caution and do not
operate the car charger when
unfocused or feel unwell.

Operation

Remove the mains plug from the mains socket before
performing any work on the car charger.
RISK OF ELECTRIC SHOCK!
DANGER OF DAMAGE TO PROPERTY!
RISK OF INJURY!

Product properties

This device is designed to charge a variety of SLA
batteries (sealed lead-acid batteries) primarily used
in cars, motorcycles and some other vehicles. These
can be e.g. WET- (with liquid electrolyte), GEL- (with
gelified electrolyte) or AGM batteries (with electrolyte
absorbent glass mat). The special design of the device
(also referred to as "three-level charging strategy")
allows the battery to be charged to nearly 100 % of
its capacity. The charger can further be connected
to the battery for extended periods to keep it in op-
timal condition.

Connecting

Before charging and trickle charging a battery
permanently connected to the vehicle, first dis-
connect the battery's negative terminal connec-
tion cable (black) from the negative battery
terminal. The negative battery terminal is typi-
cally connected to the car body.
Then disconnect the vehicle's positive terminal
connection cable (red) from the positive battery
terminal.
10 GB/IE/NI
Only then connect the battery charger's "+"
crocodile clamp (red)
terminal.
Connect the "-" crocodile clamp (black)
the "–" battery terminal. Plug the car charger's
mains cable into the mains socket.
9
Note: If the connector clamps are correctly connected,
the display will show the voltage and "connected"
will light up. If the poles are reversed, the display
will read 0.0 and "connected" will not light up.

Disconnecting

Disconnect the device from the mains.
Remove the "–" crocodile clamp (black)
the "–" battery terminal.
Remove the "+" crocodile clamp (red)
the "+" battery terminal.
Reconnect the vehicle's positive connection cable
to the positive battery terminal.
Reconnect the vehicle's negative connection cable
to the negative battery terminal.

Selecting the charging mode

You can charge a variety of batteries at different
ambient temperatures using different charging modes.
Compared to conventional car chargers, this device
features a special function for reusing a drained bat-
tery / rechargeable battery. You can recharge a
completely drained battery / rechargeable battery.
The safe charging process protects against faulty con-
nection and short-circuits. The integrated electronics
do not switch the car charger on immediately after
being connected, but only after selecting a charging
mode.
If the connector clamps connected to the battery
and the device is connected to power, the digital
display will read "Connected". After selecting a
10
charging mode, the display will read "Charging".
Once charging is complete, the display will read
"Charged".
A continuously lit display with the battery not yet fully
charged indicate a fault.
to the "+" battery
7
to
6
from
6
from
7