Installer Setting -Thermistor - Friedrich J Série Manuel D'installation

OPTIONAL OPERATION
18

Installer Setting -Thermistor

This is the function to select the temperature sensor to judge the room temperature.
FAN
SPEED
TEMP
• As the characteristic of the '2TH' function can be different in accordance with the products,
refer to the product instruction manual for its detail.
1
2
OPER
MODE
3
4
When pressing the
button simultaneously for more than 3
seconds, the system will be entered into
the installer setting mode.
- After entering into the installer setting
mode, select the thermistor sensor
setting code value by pressing the
button.
* Thermistor sensor selection code value
: 04
Select the desired setting value with the
temperature up(▲), down(▼) button.
Code value
Value
When pressing the
established thermistor sensor location will
be set up.
When pressing the
button simultaneously for more than 3
seconds after the setting has been
completed, the setting mode will be
released.
- If there isn't any button input for more
than 25 seconds, the installer setting
mode will also be released.
OPER
button and
MODE
OPER
MODE
*Setting value
01: Remote
controller
02: Indoor unit
03: 2TH
button, currently
OPER
button and
MODE