Technical Data - Seliger AQUA-STAR Mode D'emploi

SECURITY INDICATIONS
When using the AQUA-STAR, the following security indications must be
observed:
• Before putting the AQUA-STAR into operation, remove the protection cap of the
lighting.
• Use the AQUA-STAR only with the original transformer supplied.
• Risk of burns! Before touching the AQUA-STAR, switch it off and wait until it
has cooled down.
• Before touching the AQUA-STAR, disconnect the power plug from the wall
socket.
• Do not use the AQUA-STAR when the device, the connecting cable or
the transformer shows signs of mechanical damage.
• As the AQUA-STAR heats up very much when used above the water, keep heat-sen-
sitive objects away from it.
• Only use original spare parts of seliger
seliger ® assumes no liability for damage caused by non-observance of the security
indications and for damage caused to plants or animals.
Remove before use!
8 ENGLISH
® .
EXCHANGING THE HALOGEN LAMP
Pull the Transformer from the socket and wait until the Halogen lamp cools. Take the
halogen lamp out of the water. Dry the halogen lamp completely before removing the
glass head-piece.
Attention: Do not touch the bulb with your fi ngers, use a soft cloth.
Pull the defective bulb out of the lamp holder and change it for a new one (12V G4 /
max 10 W).
Insert the Halogen light with base in the glass head-piece until it fi ts correctly. The
halogen lamp is now closed completely and can be returned into the water.

TECHNICAL DATA

Transformer
Input: 230 V~ /50 Hz
Lighting
Input: 12 V~ /50 Hz
Connection cable: 3 m
Protection: Protected against overheating and overcharge.
Produced: DIN EN 60742
Output: 12V /380 mA
Watt max. 10
ENGLISH 9