Tips for saving energy
1. Install the appliance in a cool, well ventilated room , but not in direct sunlight and not near
a heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. Cover drinks or other liquids when placing them in the appliance Otherwise humidity
increases in the appliance. Therefore, the working time gets longer. Also covering drinks
and other liquids helps to preserve smell and taste.
4. Try to avoid keeping the doors open for long periods or opening the doors too frequently
as warm air will enter the cabinet and cause the compressor to switch on unnecessarily
often.
5. Keep the covers of the different temperature compartments (crisper, chiller ...etc ) closed
6. Door gasket must be clean and pliable. Replace gaskets if worn.
7. It is possible to store more food by removing freezer shelf. Energy consumption is declared
with maximum load and without freezer shelf.
CHAPTER .7
Freezer upper flap /
Freezer upper drawer
Freezer
compartment
drawers
Levelling feet
About freezer glass shelves: When the freezer is unpacked, both two of the freezer glass
shelves may be in the lower freezer shelf position. In this situation, remove the bigger shelf
and place it on the upper shelf position.
This presentation is only for information about the parts of the appliance.
THE PARTS OF THE APPLIANCE AND THE
COMPARTMENT
Parts may vary according to the appliance model.
Freezer glass shelves
EN - 27 -
Thermostat knob
Ice tray
Plastic ice blade