Beko HPI 214 B Manuel D'utilisation page 8

1 Important instructions and warnings
for safety and environment
1.8 Plug Wiring
The moulded plug on this appliance incorporates
a 13 A fuse. Should the fuse need to be replaced
an ASTA approved BS1362 fuse of the same rating
must be used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the plug must
not to be used until a replacement fuse cover has
been fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the pin
face of the plug Fuse covers are availabe from any
good electrical store.
• Fiting a different plug
• As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
• Brown cable = L (Live)
• Blue cable = N (Neutral)
• Green/yellow cable must be connected to
ground (E) line
• With the alternative plugs a 13 A fuse must be
fitted either in the plug or adaptor or in the main
fuse box. If in doubt contact a qualified electri-
cian.
8 / EN
Induction Hob / User Manual