Technical Information; Declaration Of Conformance; Inserting A Pause; Recall - Motorola D810 Série Mode D'emploi

D811_IFU_EN.fm Page 24 Friday, September 7, 2007 7:37 PM
proof of purchase bearing the date of purchase. The telephone
should also clearly display the serial number. The warranty will
not apply if the type or serial numbers on the product have been
altered, deleted, removed, or made illegible.
What Is Not Covered By The Warranty
• Defects or damage resulting from use of the Product in other
than its normal and customary manner or by not following
the instructions in this user manual.
• Defects or damage from misuse, accident or neglect.
• Defects of damage from improper testing, operation,
maintenance, adjustment, or any alteration or modification of
any kind.
• Breakage or damage to aerials unless caused directly by
defects in material or workmanship.
• Products disassembled or repaired in such a manner as to
adversely affect performance or prevent adequate
inspection and testing to verify any warranty claim.
• Defects or damage due to range.
• Defects or damage due to moisture, liquid or spills.
• All plastic surfaces and all other externally exposed parts
that are scratched or damaged due to normal use.
• Products rented on a temporary basis.
• Periodic maintenance and repair or replacement of parts
due to normal usage, wear and tear.

Technical Information

How many telephones can I have?
All items of telephone equipment have a Ringer Equivalence
Number (REN), which is used to calculate the number of items
which may be connected to any one telephone line. Your D811
has a REN of 1. A total REN of 4 is allowed. If the total REN of
4 is exceeded, the telephones may not ring. With different
telephone types there is no guarantee of ringing, even when the
REN is less than 4.
Any additional handsets and chargers that you register have a
REN of 0.

Declaration of Conformance

Hereby, Motorola declares that this D811 is in compliance with
the essential requirements and other relevant provisions of
Directive 1999/5/EC.
The Declaration of Conformance for the D811 is published on
the website: http://www.motorola.com/eu/radios/
technicaldocumentation
24

Inserting a pause

With some switchboards, after dialling the access code you
may have to wait for a moment while the switchboard picks up
an outside line so you will need to enter a pause in the dialing
sequence.
Press and hold to insert a pause (P) before entering the
u
telephone number.
You may also need to enter a pause when storing international
numbers or charge card numbers.

Recall

You may need to use the recall function if you are connected to
a switchboard/PBX (Private Branch Exchange), contact your
PBX supplier for further information.

16. Wall mounting

IMPORTANT
Before you wall-mount your D811, check that you are not
drilling into any hidden wiring.
Before you drill, make sure the power and telephone line cables
will reach the sockets.
1. Use the following templates to mark the drilling locations.
• To wall-mount the base, drill two holes in the wall 3.6cm
apart horizontally using an 8mm drill bit.
Wall mounting