Briggs & Stratton Vanguard Gasoline 540000 Manuel De L'opérateur page 9

How To Replace The Fuel Filter - Figure 10
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition

sources.
Check fuel lines, tank, cap, and fittings frequently for cracks or leaks.

Replace if necessary.
Before replacing the fuel filter, drain the fuel tank or close the fuel shut-off valve.

Replacement parts must be the same and installed in the same position as the

original parts.
If fuel spills, wait until it evaporates before starting engine.

1. Before replacing the fuel filter (A, Figure 10), if equipped, drain the fuel tank or close
the fuel shut-off valve. Otherwise, fuel can leak out and cause a fire or explosion.
2. Use pliers to squeeze tabs (B) on the clamps (C), then slide the clamps away from
the fuel filter. Twist and pull the fuel lines (D) off of the fuel filter.
3. Check the fuel lines for cracks or leaks. Replace if necessary.
4. Replace the fuel filter with an original equipment replacement filter.
5. Secure the fuel lines with the clamps as shown.
Engine Specifications
Model
Displacement
Bore
Stroke
Oil Capacity
Tune-up Specifications *
Model
Spark Plug Gap
Spark Plug Torque
Armature Air Gap
Intake Valve Clearance
Exhaust Valve Clearance
* Engine power will decrease 3.5% for each 1,000 feet (300 meters) above sea level and 1% for each 10 F (5.6 C) above 77 F (25 C). The engine will operate satisfactorily at an
angle up to 15. Refer to the equipment operator's manual for safe allowable operating limits on slopes.
Service Part
Air Filter, Cyclonic
Safety Filter, Cyclonic
Air Filter, Low-Profile
Pre-Cleaner, Low-Profile
Oil -- SAE 30
Oil Filter
n We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts.
en
Specifications
540000
54.68 ci (896 cc)
3.366 in (85.5 mm)
3.071 in (78.0 mm)
78 -- 80 oz (2.3 -- 2.4 L)
540000
0.030 in (0.76 mm)
180 lb-in (20 Nm)
0.005 - 0.008 in (0.13 - 0.20 mm)
0.004 - 0.006 in (0.10 - 0.15 mm)
0.004 - 0.006 in (0.10 - 0.15 mm)
Common Service Parts n
Part Number
841497
821136
692519
692520
100028
842921
Storage
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
When Storing Fuel Or Equipment With Fuel In Tank
Store away from furnaces, stoves, water heaters or other appliances that have

pilot lights or other ignition sources because they can ignite fuel vapors.
Fuel System
Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum
deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh,
use Briggs & Stratton Advanced Formula Fuel Treatment & Stabilizer, available
wherever Briggs & Stratton genuine service parts are sold.
For engines equipped with a FRESH START
START available in a drip concentrate cartridge.
®
There is no need to drain gasoline from the engine if a fuel stabilizer is added according
to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel
system before storage.
If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into
an approved container. Run the engine until it stops from lack of fuel. The use of a fuel
stabilizer in the storage container is recommended to maintain freshness.
Engine Oil
While the engine is still warm, change the engine oil.
Troubleshooting
Need Assistance? Go to VanguardEngines.com or call 1-800-999-9333 (in USA).
Engine Specifications
Model
Displacement
Bore
Stroke
Oil Capacity
Tune-up Specifications *
Model
Spark Plug Gap
Spark Plug Torque
Armature Air Gap
Intake Valve Clearance
Exhaust Valve Clearance
Service Part
Fuel Filter
Fuel Additive
Resistor Spark Plug
Long Life Platinum Spark Plug
Spark Plug Wrench
Spark Tester
fuel cap, use Briggs & Stratton FRESH
®
610000
60.60 ci (993 cc)
3.366 in (85.5 mm)
3.406 in (86.5 mm)
78 -- 80 oz (2.3 -- 2.4 L)
610000
0.030 in (0.76 mm)
180 lb-in (20 Nm)
0.005 - 0.008 in (0.13 - 0.20 mm)
0.004 - 0.006 in (0.10 - 0.15 mm)
0.004 - 0.006 in (0.10 - 0.15 mm)
Part Number
691035
5041, 5058
491055
5066
19374
19368
9