Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER INSTRUCTIONS
SELECTED
ON TIME SETTING (PROGRAM 1):
7.
AM
PM
8.
ON
OFF
9.
1
2
10. To select minutes press
11. To confirm press
OFF TIME SETTING (PROGRAM 1):
12.
AM
PM
13.
ON
14.
OFF
1
2
15. To select minutes press
16. To confirm press
NOTE:
Either continue to PROGRAM 2 and set on and off times
or stop programming at this point, and PROGRAM 2 re-
mains deactivated.
NOTE:
PROGRAM 1 and 2 use the same on (Thermostatic) and
off temperatures for
, ). Once a new on (Thermostatic) and / or off tempera-
ture has been set, that temperature becomes the new
default setting.
NOTE:
If
,
or Daily Timer are programmed for PRO-
GRAM 1 and PROGRAM 2 on and off times, these be-
come the new default times. The batteries must be re-
moved to clear the PROGRAM 1 and PROGRAM 2 on
and off times and temperatures.
or Daily Timer ( , , , , , , ) selected
▪ Set on time and off time using same procedure as "
Selected" (above).
▪
: Set on time and off time for both Saturday and Sunday.
▪ Daily Timer: Unique on and off times may be set for a single
day of the week, for multiple days of the week, or for every day
of the week.
▪ Wait to finish setting.
, ,
displayed,
is displayed
shortly, and hour flashes.
To select hour press
or
To confirm press
button.
displayed,
displayed shortly,
and minutes flash.
or
ton.
button.
, ,
displayed,
is displayed
shortly, and hour flashes.
To select hour, press
or
To confirm press
button.
displayed,
displayed short-
ly, and minutes flash.
or
ton.
button.
,
and Daily Timer ( , , , , ,
AUXILIARY FEATURE (2ND BURNER FEATURE)
The latching solenoid valve will open automatically after ignition
or after switching the system off, so that the maximum flow of
gas is supplied to both burners assisting with the ignition pro-
button.
cess. After pressing the AUX-button the motor will turn 7 sec-
onds in the ON direction until the max. position is reached.
, ,
but-
AM
PM
ON
OFF
1 2
button.
, ,
NOTE:
The latching solenoid valve cannot operate manually. If
the Receiver battery runs down it will remain in the last
but-
operating position.
ECO MODE
AM
CIRCULATING FAN OPERATION
AM
NOTE:
SETTING only. If the fan was not switched off after last
use, it starts automatically 4 minutes after ignition at max-
imum speed and goes to the last set level after 10
sec-onds. The fan stops 10 minutes after the gas is
OFF or at Pilot.
ON:
To switch a burner on, press the
ton.
displayed.
OFF:
To switch the burner off, press the
button.
disappears.
ON:
Press
button to enter Eco Mode.
displayed.
OFF:
Press
button.
disappears.
Circulating fan has 4 speed levels from
low (1 bar) to high (4 bars).
SETTING:
1.
Press
button and hold until
flashes.
2.
Press
button to increase fan speed
and
button to decrease fan speed.
3. To confirm setting either press
ton or wait (
displayed).
OFF:
Press
button until all 4 speed level
bars disappear.
but-
but-
37
Publicité
Table des Matières
