Switching On - Atag HL70 Q Série Mode D'emploi

safety
what you should pay attention to
The ceramic cooking surface is very strong but not
unbreakable. It may be cracked if, for example, a spice jar or
pointed object falls on it.
Do not use the appliance if there are any cracks or splits in it.
Switch the appliance off immediately. Take the plug out of
the socket and phone the service department.
Do not use aluminium foil, such as the trays from ready-made
meals, for cooking food in.
If aluminium foil melts on the cooking surface, it cannot be
removed.
Grains of sand may cause scratches that cannot be removed.
• Only put pans with a clean and dry base on the cooking
surface. This prevents lime stains or other stains that are
difficult to remove.
• Always pick pans up to move them.
• Do not use the hob as a worktop.
Always pick pans up;
never slide them.
Cords to electrical appliances – e.g. a mixer – may
accidentally touch the cooking zones.
GB 6
introduction
The ceramic hob is fitted with a residual heat indicator, fast-
cook settings, a timer, a childproof lock, an automatic cooking-
time limiter and a double cooking zone. On this page and the
following ones, you can read how to use these facilities.

switching on

1 Put a pan on a cooking zone.
2 Press the on/off button.
A horizontal line (–) appears in the display.
on/off button
setting the power level
1 Press the + or – button for the cooking zone concerned.
Press the + button. The hob goes directly to setting 12.
Press the – button. The hob goes directly to setting 1.
2 Select a higher or lower setting by pressing the + or –
buttons again.
higher lower The display shows the setting selected. You can see
which setting to select in the cooking tables on page 11.
switching on double-ring zone
switching on
Press the button.
The light above the button comes on. The fish-kettle or
fish-kettle zone button double-ring zone switches on.
You cannot use the outer ring on its own.
switching off
double-ring zone
Press the button again and the zone switches off.
button
operation
switching on
GB 7