General Information; During Use; What You Should Pay Attention To - Atag HL70 Q Série Mode D'emploi

your ceramic hob

general information

When you first connect the appliance to the mains it will test
itself automatically and the displays will light briefly.
If you do not select a setting within 5 seconds the zone will
switch itself off automatically.
The control panel uses touch controls.
You can switch in the timer for the two rear zones so that at
the end of the cooking time the zone will be switched off
automatically.
The appliance is equipped with synchro-start. If you have an
extractor hood that is also equipped with synchro-start, it will
start up automatically when you use the controls on the hob.
GB 4

what you should pay attention to

when installing the appliance
This appliance should only be connected up by registered
installer.
Never open the casing of the appliance.

during use

This appliance has been designed for domestic use. You
should only use it for cooking food.
The appliance is hot both during and after use. Bear this in
Watch out with
mind if young children come anywhere near the appliance.
young children; the
appliance is hot
Do not place any objects on the touch controls. Doing so will
during and after use.
cause the hob to switch off and an error code will appear.
Never leave an empty pan on a cooking zone that is switched
on. Do not allow the pan to boil dry, either.
Although the hob is protected against overheating, the pan
will get very hot, which may damage it.
Do not use pans that are smaller than the cooking zone. This
will prevent food remains ending up on the red-hot cooking
zone. Burnt-on food remains are difficult to remove.
Do not use pans that
are smaller than the
cooking zone.
Grease and oil are flammable when overheated. Stay near
the cooker when preparing dishes.
Damage arising from the use of unsuitable pans or from
boiling dry is excluded from the guarantee.
safety
GB 5