Specifications - JUKI DLN-6390 Manuel D'utilisation

!. SPECIFICATIONS

Application
Max. sewing speed
Stitch length *1
Needle
Needle bar stroke
Thread take-up stroke
Hook
Lift of presser foot
(Between upper feed roller and lower roller)
Feed method
Hemming binder open/close method
Lubricating oil
Stitch length adjusting method
Needle clamp method
Motor
Noise
*1. Do not set the scale of feed dial to change the needle feed amount to 2.1 or less.
DLN-6390-7
Bottom hemming, waist band attaching (lockstitch type), hemming (lockstitch type)
When stitch length is less than 3.6 mm : 5,000 sti/min
When stitch length is not less than 3.6 mm : 4,500 sti/min
* *
2.1 mm, 2.3 mm, 2.5 mm, 2.8 mm, 3.2 mm (standard), 3.6 mm, 4.2
SCHMETZ UY180GVS Nm140 (shank diameter φ 1.84)
Range of use : Nm90 to Nm150 (equivalent to #14 to #22.5)
Exclusive automatic lubricating full-rotary 1.7 fold hook
Presser lifting lever : 4.5 mm
Auto-lifter : 13 mm (Max. 14 mm)
Upper/lower roller continuous feed method
Air cylinder drive
JUKI NEW DEFRIX OIL No. 1
or JUKI MACHINE OIL #7
Gear replacement method
SC-921/M51N
- Equivalent continuous emission sound pressure level (L
A-weighted value of 80.0 dB; (Includes K
-ISO 11204 GR2 at 5,000 sti/min.
– 1 –
DLN-6390
35 mm
123 mm
Knee lifter (by manual) : 13 mm (Max.14 mm)
By manual
Nut clamp method
400W or higher power clutch motor can be used.
) at the workstation :
pA
= 2.5 dB); according to ISO 10821- C.6.2
pA
* *
mm : Optional