Setup The Weather Server Connection - Explore Scientific WSX3001 Mode D'emploi

SETUP THE WEATHER SERVER CONNECTION

Enter the following information into the below web interface "SETUP" page to connect the
console to weather server, If you do not want to use Wunderground.com or Weathercloud.net,
please empty the station ID & key to ignore the data upload.
Press to search router
Press to allow add
router manually
Enter the Latitude value
Enter the Longitude
value
NOTE:
- When WI-FI setup is completed, your PC or mobile will resume your default WI-FI connection.
- During AP mode, you can press and hold the [ SENSOR / WI-FI ] key for 6 seconds to stop
AP mode and the console will restore your previous setting.
TIME ZONE
To automatically set the time display to your time-zone, change the time zone in SETUP page
of previous section from '0:00' (default) to your time zone (e.g.+1:00 for Germany).
SETUP page
SETUP
Language:
WiFi Router setup
Search
Router: ROUTER_A
Add Router
Security type: WPA2
******
Router Password:
Weather server setup
Wunderground
Station ID: WDw124
******
Station key:
Weathercloud
Station ID: IPACIR23Wc
Station key:
******
URL:
http://ws.awekas.at
Station ID: IDCR21w1
******
Station key:
Mac address
00:0E:C6:00:07:10
Time server setup
Server URL: nist.time.gov
Time Zone: 0:00
Location for sunrise / sunset
*Latitude: 0.0000
Enter 0 to 90, no negative numbers
0.0000
*Longitude:
Enter 0 to 180, no negative numbers
Hemisphere N
* Depends on the model
Firmware version: 1.00
ADVANCED
English
North
East
Apply
15
Press "ADVANCED" icon
to Advanced page
Select setup UI display language
Select router (SSID) for connection
Manually enter the SSID if not on list
Select router's security type (usually
WPA2)
Router's password (leave blank if the
Security type is "Open")
Enter new Station ID and Station key
that assigned by Wunderground
Enter new Station ID and Station key
that assigned by weathercloud
Add another weather service
(e.g. AWEKAS).
Enter new Station ID and Station key
that assigned by the corresponding
weather server
Select time server
Select time zone of your location
Select the direction (e.g. EU
countries Longitude is East and US
is West)
Select the sensor located hemisphere
(e.g. US and EU countries are also "N",
Australia is "S")
Press to complete the setting
EN