Power Connection - Honda Miimo HRM40 Guide D'installation

Power connection

4 4
Feed the power supply cable
4.1
through the docking station cover
and into the docking station.
Do not clip the cover yet, you will do this in step 5.9.
Check that the status indicator on the docking station is
now continously illuminated!
Switch on Miimo.
4.2
The on/off switch is located at the back of the mower. Please note, if the mower is not turned on, it will not charge.
At this point, nothing will be shown on the display.
Slide the mower into the docking
4.3
station for charging.
Make sure the on/off switch is on ( I ) before placing the Miimo
in the docking station.
Although your Miimo is already partly charged, it is
recommended to fully charge it before using it for the first time.
Never carry Miimo from its sides. Always use the rear handle.
12
OFF
ON