Before Beginning Installation - Carbest 47348 Manuel D'utilisation

ENGLISH 47348

BEFORE BEGINNING INSTALLATION

Before drilling please check that no cable or wiring is on the other side of the wall.
Please clamp all wires securely to reduce the possibility of them being damaged
while vehicle is in use. Keep all cables away from hot or moving parts and electrical
noisy components.
Step 1: Choose the monitor and camera locations.
Step 2: Install all cables in vehicle, when necessary a 0.8 (20 mm) hole should be
drilled for passing camera camera cable through vehicles walls. Install split
grommets where applicable.
Step 3: Once all cables and wiring have been properly routed and the system has
paired, perform a system function test by temporarily connecting the system.
If the problem persists see troubleshooting.
We recommend doing a benchmark test before installation to insure that all
components are working properly.
SYSTEM COMES PAIRED.
● But if there is no image on monitor, your system is NOT paired
and needs to be paired.
25