Extel WECACV 70003 Guide D'installation Et D'utilisation page 11

3.
Remark: the channel 1 corresponds to the key A of the remote control
the channel 2 corresponds to the key B of the remote control
the channel 3 corresponds to the key C of the remote control
the channel 4 corresponds to the key D of the remote control
the other channels will control only the receptors of WEATER3 kit.
A
1st use:
Installation code
Type ENTER + 999999+
ENTER to enter
programming code
Leds L1 - L2 lit + BIP for
3s, then
the leds switch off
Type 1 + ENTER
Led L1 lits
Type 999999 + ENTER
Long BIP
Type the new installation
code with (6 digits) +
ENTER
Long BIP
Confirm typing the new
installation code with
(6 digits) + ENTER
Caution: in case of inactive keyboard for 30 seconds, You go out programming mode. Repeat the procedure
from the beginning.
6. PROGRAMMING THE CODE KEYBOARD
ON THE RECEPTOR OF THE DEVICE TO CONTROL
In order your code keyboard can communicate with the device to control, you should refer to the device instructions
and repeat the same procedure as for programming your remote control. For this programming, instead of pushing a
button of the remote control, dial the access code on the keyboard. The programming is made automatically.
Caution: Keep your codes on a secure place, because if you forgot them, you will not be able to use your code
keyboard.
Battery level indicator
Push a button:
1) If you hear a short bip when pushing: the battery is good.
2) If you hear a 2 second bip, the battery is charged at 50%.
Any programming is then impossible but the control is possible.
3) If you hear short 3 bips 3 times, the battery has to be changed.
Any programming or control is then impossible
This device is guaranteed for labour and parts in our premises.
The guarantee does not cover: the consumables (batteries, etc.) and the damages caused by: misuse, improper installa-
tion, external intervention, deterioration by mechanical or electrical shock, fall or atmospheric phenomenon.
B
Programming
an access code
Type the channel number (from 1 to 9) + ENTER
Type your access code channel
number (1 to 9) + (0 to
7 digits) + ENTER
Confirm the access code chan-
nel number (1 to 9) +
(0 to 7 digits) + ENTER
Leds L1 and L2 lit + BIP for 3s, then the leds switch off
END OF PROGRAMMING
http://www.bakonline.net/
CFI EXTEL WECACV 70003 - 11/2011
4.
Type ENTER + installation code (6 digits)
+ ENTER
Leds L1 - L2 lit + BIP for
3s, then
the leds switch off
Type 2 + ENTER
Led L2 lits + 2 long BIP
Long BIP
Long BIP
C
Erasing an
access code
Type 0 + ENTER
Long BIP
Type 0 + ENTER
GB